LC Design Systems

Custom Office Partitions and Components

Electric Partitions

E Partitions can carry power and data lines

LC E-Partitions

Panels are equipped with electrical conduits with universal ports. The ports are covered with attractive covers and will accept standard electrical hardware. We can prewire them, or your electrician can supply wiring and outlets to suit your needs. The panels can be accept 110 volt or higher voltages if necessary, telephone, and computer (digital) network wiring, or any combination. E-Panels will interconnect with standard LC Panels so that you only run your wires where you need them. Thus, keeping your costs down.

 

Pricing

Sizing up to 4'x6' 4'x10
Standard E Panels: $219 $249
Single conduit panels: subtract $10 per pane
Prewired E Panels: add $47 per panel

 

Prewired E-Partitions

These panels can carry electricity in 2"x2" conduits. We prewire the lower conduit as shown above using standard male/female plugs on each end. One panel can be "plugged into" the next panel. Once connected, the plugs and wires can be pushed back into the panel conduit for a clean appearance. Many panels can be connected together this way. The first panel can get power by plugging it into a wall outlet, or extension cord. In a modern world where you may have a wireless router for your computer systems, you may not need the upper conduit. These panels can be made with a single conduit if needed and saves $5 per panel. For prewiring, add $47 per panel.

pre wired e panel with acrylic top

Prewired E-Panel with an acryilc window (and protective film) at the top. This example shows our versatility in meeting your needs.

Standard E Partitions

epanel, a pre-wired office partitionThese panels are supplied with single or dual conduits but are not prewired. This way, the end user can have them wired by their electrician for their specific application. The conduits are large at 2"x2" square, and will accomodate very high voltages. Normally, the high voltage is carried in the lower conduit, and low voltage, such as telephone or computer wires are carried in the upper conduit. Any sort of standard electrical hardware should fit the conduit ports.

Connectors

epanel, pre-wired partition connector possibilitiesWe have connectors ("Hi-Lo left", or Hi-Lo right") that will allow you to attach tall panels to shorter ones. The Standard LC Panel (shown) can actually be connected anywhere along the face of E-Panels by using our T-Connectors. A whole series of standard panels can be attached along both sides of this line of E-Panels if desired.

Wiring

conduits in pre-wired epanelsE-Panels come equipped with standard 7/8" ID holes for wiring. These may be enlarged for bigger wire applications. Two heavy duty square steel conduits 2"x 2" will carry electricity, telephone and digital cable, or any combination. The bottom edge of the lowest conduit is 16 1/2" from floor.

 

Power Poles

power pole epanelsA typical power pole is a 2" square metal tube. High voltage is run throught the tube. Low voltage like telephone and digital cable generally come "shielded", and can be run through the same tube. If you need a special design, let us know, and we'll try to make it for you. $69 each, up to 10 feet lengths. Taller poles can cost a bit more.